1. Manufacturing method of sports phone pockets
Material: printed canvas.
Steps:
1. First, measure the size of your mobile phone + case, and then add a little relaxation to the size of the bag.
2. According to the drawings and patterns, draw the outline on the reverse side of the canvas, add seam allowances, and cut. (Note: If there is no special mark, the drawings and paper patterns do not contain seam allowances.)
3. Those with tapes are used as surface cloths, and those without tapes are used as linings.
4. The front of the lining and the table are opposite, and the four sides are aligned. Draw a 1*20 rectangle in the middle, and press the line.
5. Cut the inside of the rectangle, and turn the lining to the bottom of the surface.
6. Iron flat, prepare to install the zipper of the zipper head, and place the zipper under the rectangle (the side of the lining) and press the line around it.
7. Turn it over to the reverse side, fold the two ends of the inner fabric inward, and fold a seam allowance with the outer fabric.
8. The surrounding yardage where the outer and inner fabrics overlap, then the outer fabric is inside, the inner fabric is outside, and the zipper is pressed in half and stitched.
9. Don’t sew too long at both ends here, otherwise the strap will be difficult to turn out.
10. Turn to the front, turn the straps out, iron the straps inwards to make the seam allowance, then fold them in half, and press the thread on the front, all the way to both sides of the bag body.
11. Finally, install two mouth buckles, and the mobile phone pocket is completed.
Second, The production method of jeans pockets
Steps:
1. Cut a section of the trousers leg, the size of the jeans is different, so don’t write the size .
2. If it’s not a straight-leg trousers, just trim off one side and be neater.
3. Prepare a piece of lining of the same size.
4. Sew a small bag on the table cloth.
5. Add a small lid.
6. Treat both ends of the zipper.
7. Sew on the zipper, and the zipper is sewn between the outer fabric and the inner fabric.
8. Fold both ends.
9. Both ends are the same.
10. Prepare two pieces of trapezoidal cloth, with four pieces at both ends.
11. Sew the two edges on the front facing each other.
12. Flip to the front.
13. Tuck the side of the bag into the trapezoidal long side to sew. The denim itself is very thick, plus it is wrinkled and becomes super thick. For the sake of strength and beauty, use cross stitch.
14. Both sides are the same.
15. Cut the other trouser leg decisively to make a belt
.
16. What else to decorate, let your imagination run wild.
17. You’re done, take it to travel.