What is the size of the integrated ceiling-mounted bathroom heater
The bathroom heater installed on the ceiling is called a ceiling-mounted bathroom heater, and there are two main sizes:
The size of the traditional four-lamp lamp heater is: 300*300
For integrated ceiling: 600*300.
Both sizes can be used by appropriate means.
In the past, long strips of gussets, gypsum boards, etc. were used in kitchen and bathroom installations. During installation, it was necessary to cut out corresponding openings according to the size of Yuba. This kind of ceiling is supported by wooden rails, and the traditional Yuba can be directly fixed on the wooden rails. The integrated ceiling Yuba can also be installed on this kind of ceiling, but through a conversion frame, the Yuba and the wooden fence are fixed together.
The integrated ceiling is a fixed size, each piece is 300*300, 600*300 and other sizes, so there is no need to cut it during installation, just remove one or two pieces to install the Yuba. The integrated ceiling Yuba is designed to be 600*300 size for the convenience of installation. This kind of Yuba (including other integrated ceiling appliances, such as lighting, exhaust fan, etc.) is very convenient to install. There are buckles on these modules. When installing, you can directly clamp the corresponding position of the ceiling, which is convenient and reliable. For the detailed installation process, please refer to the integrated ceiling installation guide!
Ordinary Yuba can also be installed on the integrated ceiling, just need to buy a conversion box!
Introduction to the size of each type of ceiling bathroom heater
Dimensions of 4-lamp bathroom heater: 380MM* About 380MM
The size of the bathroom heater with 2 lights on the wall: 450*210*180 about
The installation size of the bathroom heater with 4 lights: 300*300 (there are exceptions, but it is not only about 2%) 300*300).
Infrared heating tube five-in-one Yuba size: 600*300*1700
Integrated ceiling multi-function flat-screen Yuba Dimensions: 300*300*125
Four Lamp three-in-one negative ion Yuba size; 300*600*150
Three-in-one multifunctional Yuba size: 360*360*170
Ordinary ceiling non-integrated Yuba size; 370*370 *150
Three-in-one combination embedded Yuba Dimensions: 350*350*300
How to install Yuba
Yuba installation preparation Work: Start the air hole and install the ventilation window. Generally, the ventilation pipe of the ventilation window needs to be about 1.5 meters, and when installing, pay attention to the center of the installation position of the Yuba, so the distance between the ventilation holes should not exceed 1.3 meters.
Determination of the installation position of the Yuba: The installation position of the Yuba should be directly above the bathtub or shower room, so the ceiling of the bathroom should use materials with better strength. After installing the Yuba, ensure that The height difference between the Yuba lamp bulb and the ground is between 2.1 and 2.3 meters.
Yuba installation process: preparation for ceiling installation – take off the cover (unscrew the bulb, take off the cover from the spring from the ring of the mask) – wiring (connect the Yuba and the switch panel with a flexible wire) – Connect the ventilation pipe – push the box into the air hole – fix the Yuba lamp – install the mask.
The final process of Yuba installation: install the Yuba bulb (install the bulb, and then connect the line of the lamp holder. Usually, after the installation is completed, wipe the light bulb and the mask clean) – fix the Yuba switch (determine the bearing capacity of the power cord) Pull to secure the switch to the wall.)
