Lighter Electric Lighter Rechargeable Arc USB Candle Lighters with LED Battery Display; SEE MORE >>>
[Spotlight] What is the principle of the pistol
How to use the pistol
Check Work
Before using a musket, you should do the necessary inspection work. In fact, this step is often ignored by everyone, but the preparation work is very necessary. After all, it is a product with a risk factor. Check whether the gun is in a state of air leakage. If so, be sure to tighten its surrounding parts, and whether the air valve is also tight. Beware of fire suddenly rushing out when it is opened.
Adjust the ignition gun
Turn on the equipment that needs to be ignited. If it is a gas stove, try to keep the distance as far as possible to prevent the sparks from hurting others or yourself. Turn on the ignition gun. The air valve can be easily ignited, just like the principle of a lighter. Generally, it can be opened in one step. Remember to turn off the ignition gun after ignition. It cannot be placed aside. For industrial use, such as burning excess If you want to restore the product, you should also pay attention to closing the equipment that needs to be operated in time. The air valve of the musket is determined according to the degree of burning the product.
Precautions for use
When using a light gun, the most important thing to pay attention to is not to point the flame towards some flammable objects, etc., because it is a flame The temperature will be relatively high, which is prone to fire accidents. When the ignition gun is used, be sure to close the gas valve. Some ignition guns need to be refueled by themselves. Be sure to remember to tighten the plug in time after adding fuel. The ignition gun with dangerous items must be placed in a cool and ventilated place. , so that if the leak can be found and dealt with in time, it is best not to use a light gun when smoking to avoid safety problems.
What is the principle of the ignition gun
System composition
The ignition device consists of igniter, ignition cable , semiconductor spark plug, conductive rod, together with the propeller to form a complete ignition device.
High Energy Igniters
Oil Guns and Gun Thrusters
Steam Purge Valves
Oil Valves
Flame detector
Function
Control the advance and retreat of oil gun and ignition gun, and give position signal;
Control oil Valve switch and steam purge valve switch, and give valve position signal;
Control ignition time;
Give ignition flame signal;
Implement the remote control room and turn off the flame;
Directly ignite light oil (or heavy oil, natural gas and other fuels).
Use
1. The igniter works in a gap, and the ignition time should not be too long. Oil (gas) ignition; general ignition time cannot exceed 30 seconds.
2. The fuel should be well atomized, and the poor atomization quality will affect the ignition success rate.
3. The ignition device works for 30 seconds, and should rest for 2 minutes before use, to avoid continuous long-term use.
4. The ignition gun should exit the furnace immediately after lighting the oil gun to avoid burning out.
Faults and Troubleshooting
1. Fault phenomenon: normal voltage, but no ignition or slow ignition frequency
Fault reason: The electrodes at both ends of the high-voltage shielded cable are in poor contact with the igniter and the ignition gun, and the ignition voltage is low.
Remedy: tighten the contact parts and increase the ignition voltage
2. Fault phenomenon: the ignition is normal , but does not catch fire
Cause of failure: poor atomization of the oil gun When the cold furnace ignites, the water spray has no oil, and the ignition gun is not in the best ignition position
Remedy: clean the oil circuit , remove the moisture in the tubing, adjust
