[How to disassemble a desktop fan] Introduction to a desktop fan p> There are certain differences in the internal composition of desktop fans of different brands and models, and they will also be different when they are removed. If consumers need to dismantle the desktop fan by themselves, they can first find out the instructions provided with it, and then reverse the order to disassemble according to the assembly diagram.
Generally speaking, desktop fans generally have a fixed plastic ring, and after unscrewing the screws on it, the fan cover of the desktop fan can be easily removed. After that, the fan blade can be removed.
If you need to clean the desktop fan, you need to dry the fan blade until it is completely dry before assembling it back, otherwise it will easily cause safety problems.
2 components of a desktop fan
A desktop fan is generally composed of a fan base, fan blades, fan cover and the rear case of the fan. The desktop fan is easy to move and can fully spread the force when it is lifted, so that consumers can easily lift it. In addition, the desktop fan also has the functions of low energy consumption and quietness.
3 gears of the desktop fan fail
The gear of the desktop fan fails means that there is no obvious change in the wind speed when adjusting the fan speed. The wind speed in each gear is about the same. If this happens, there are generally three possibilities.
First of all, you can disassemble the desktop fan and check whether the motor spindle part is relatively dry. If it is, just drizzle some lube on it. If not, it may be caused by the failure of the capacitor, then you need to contact the maintenance personnel to replace the capacitor. Another possibility is that there is a short circuit inside the motor, and you need to contact a professional maintenance person to replace the motor.
4 desktop fans installation
Specific parts: a fan blade, front and rear guard rails, a fan original motor, a Torx screwdriver, Front screw and rear screw
Installation steps: first unpack and check whether the above mentioned parts are complete.
1. Next, remove the front screw and rear screw of the original electrical parts respectively. (Picture below)
2. Put the rear guardrail at the motor and tighten it with the rear screw.
3. Put the fan blade into the rear guardrail, put it on the front screw and tighten it.
4. Use a screwdriver to remove the leather strip on the guardrail and turn it a few times, then put on the front guardrail and tighten the leather strip with a screwdriver. In this way, the beautiful and practical table fan is installed, does it save the installation cost?
