[Atomizer cleaning and maintenance] How to clean and disinfect the medical atomizer and how to maintain and maintain the atomizer

[Atomizer cleaning and maintenance] How to clean and disinfect the medical atomizer and how to maintain and maintain the atomizer

How to clean and disinfect the nebulizer

1. If there is no relevant disinfectant and you are at home, after each cleaning, Rinse the pipe clean, scald it with boiling water and let it dry.

2. If you want to use drugs to disinfect, you can buy chlorine-containing preparations or disinfectants at the pharmacy, soak them in a half-hour, rinse them, and dry them for later use.

3. After the treatment is over, be sure to thoroughly disinfect the nebulizer to prevent infection in the next use, and keep the instrument dry.

4. Before using the nebulizer, clean and disinfect the cup that contains the medicine to prevent contamination.

5. When the atomizer is not used for a long time, the above methods should be used to clean, disinfect and dry before use.

Atomizer Maintenance

Please keep the atomizer in the best condition and follow the following seven precautions to avoid damage to the atomizer :

1. Do not place the nebulizer in the reach of infants or unconscious patients.

2. Do not subject the atomizer to any strong impact, such as dropping the atomizer from a height.

3. When there is liquid medicine in the liquid medicine bottle, do not carry or store the nebulizer.

4. Do not place the atomizer in a place with high temperature, low temperature, high pressure or direct sunlight.

5. Do not break the trachea.

6. Regarding the disposal method of the discarded main body, accessories and optional parts, please follow the regulations of the local government.

7. Do not use benzene, thinner and flammable chemicals to clean the atomizer.

Replace the nebulizer filter

When the filter becomes discolored, please replace it with a new filter. The operation steps are as follows.

1. Pull out the filter cover and remove it to replace the filter.

2. Use a sharp tool such as a toothpick to remove the filter. Discard the removed filter and replace it with a new one.

3. Install the filter cover.

NOTE:

Use only the filters designed for this nebulizer. Do not use this nebulizer without the filter installed.

The filters are front and back.

Before replacing, make sure the filter is clean and free of dust.

Do not wash the filter. If the filter is wet, replace the filter. When the filter gets wet, it will cause clogging.

To prevent clogging of the filter cover, please clean the filter cover regularly. Do not boil the filter cover. When cleaning, be sure to remove the filter cover first. After washing, dry thoroughly and install the filter cover in the correct way.

Precautions for the use of the atomizer

1. Before use, check whether the machine is installed properly. Do not put warm water or hot water in the atomizer cup.

2. The inhaled medical drugs must be water-soluble, have good stability, low viscosity, and be suitable for the colloidal osmotic pressure of the human body.

3. Be gentle when using, do not use too much force when pulling out the atomizing cup, do not damage the mouthpiece and break the catheter, otherwise it will affect the next use.

4. The inhalation time of each atomization should not exceed 20 minutes, and the liquid addition should not exceed 6 ml.

5. When the nebulizer is filled with liquid medicine, do not carry or store the product; do not place the product where infants or unconscious patients can reach.

6. If the atomizer is used continuously, the interval should be 30 minutes, and the disinfection should be carried out after the end.

7. When using the mouthpiece, do not bite too hard, only hold it lightly to avoid damage caused by the broken mouthpiece.

8. When the operating temperature of this product exceeds 60 degrees Celsius, it will automatically stop working.

9. Handle the atomizer with care, avoid bumping, and prevent the atomizer cup and shell from being broken; do not pull the power cord, and form a ring to straighten it out when not in use to prevent circuit breakage or skin damage.