I. Can the motorcycle be equipped with a car charger?
The car charger is installed on the car, and the car battery is used to charge the mobile phone and other smart devices using the cigarette lighter device, then the car charger can be used for motorcycles?
The answer is yes, you can also install car chargers on motorcycles. Many people think that it is useless to install car chargers on motorcycles. In fact, motorcycle car chargers are not intended for ordinary people. Yes, for friends who like motorcycle riding, they may need a car charger to charge their smartphones or action cameras and other devices for easy riding. So how does a motorcycle install a car charger?
Second, how to install the motorcycle on-board mobile phone charger
The installation of the motorcycle on-board charger is mainly in terms of wiring, and you can directly purchase the one produced by a regular manufacturer. USB car charger, first make two leads of the charger power supply, the middle is the positive pole, and the shrapnel on both sides is the negative pole (be careful not to connect it in reverse, otherwise it may burn); choose the inner side of the shroud or other waterproof position, put the It is fixed, and then connect the positive wire to the positive pole of the front brake switch wire, and the negative pole to any position that can be grounded. After the cable is connected, buy a mobile phone holder and fix it on the handlebar, and you can charge the mobile phone while riding.
Third, how to wire the motorcycle on-board mobile phone charger
It should be noted that if the motorcycle is turned off for a long time without unplugging the on-board charger If the device is installed, it may cause some damage to the battery, so you can take another wiring method, although it is more troublesome, but it is safer to use later.
The principle of this method is to control the USB charging interface through the ignition switch, which can protect the battery through the original protection function of the motorcycle and prevent short circuit; In the state, the power-off function is realized to protect the USB interface. The specific operation of this wiring method is as follows:
The negative pole is connected to the frame part or the negative pole of the battery at will, and the positive pole is connected through the ignition switch outlet. There may be some motorcycles with different models and the line colors will change, but just find the flasher and connect it.
