[gps locator] How to install GPS
locator to prevent car GPS locator from being removed by thieves
GPS locator has been widely used and is very common. In the automotive industry, it is an indispensable anti-theft positioning device, which plays an important role in vehicle management and vehicle anti-theft. GPS trackers are very advanced risk control equipment in some industries, but in certain industries, there is no secret at all, and it is inevitable to be removed, so how to prevent GPS trackers from being removed is a problem that practitioners in specific industries have to consider. .
So how exactly do you prevent the GPS tracker from being removed? What are the effective ways to prevent the GPS locator from being removed?
1. An tamper-resistant GPS locator can be used to increase the difficulty of dismantling when the equipment is destroyed.
2. Use a GPS locator with a backup power supply. When the external power supply is damaged, it can still locate for a short time and issue an alarm message.
3. The installation should be as concealed as possible. Install the device in a place on the vehicle where it cannot be easily found.
4. After dismantling, the track playback function can be used to find the movement patterns of people or vehicles.
5. When conditions permit, two GPS locators can be installed, and thieves will take it lightly after dismantling one, and often will not look for the other.
The GPS locator is a terminal with built-in GPS module and mobile communication module. It is used to transmit the positioning data obtained by the GPS module to a server on the Internet through the mobile communication module (gsm/gprs network). , so that you can query the terminal position on the computer.
Installation method
The external power supply GPS tracker must be connected to the car power supply before it can work 24 hours a day. Generally, criminals want to use this product to track other people’s vehicles , is impossible. Because it must be connected to the car power supply, it is different from the general external locator. Therefore, it is not recommended to use an external power supply.
Installation method
1. If you know electricity, you can install it yourself. In fact, you only need to find the positive and negative poles of the car power supply. The negative pole is very easy to find. The place where the body is grounded is the negative pole, the positive pole is found in the fuse box, near the car key switch or directly connected to the battery;
2. It is best to connect to the normal power supply, which is not affected by the car key switch , the power cord directly drawn from the car battery;
3. Note that the side of the GPS locator with the light should face the sky, and the side facing the sky should not be close to the metal object to block the internal GPS antenna. Receive satellite signals from 20,000 kilometers away;
4. You can also ask relevant technical personnel to install it, and the fee depends on the local situation!
Installation location
1. Above the front windshield at the roof lights;
2. Below the front windshield Hidden in the trim panel;
3. Hidden around the front dashboard;
4. In the door bulkhead;
5. Under the rear windshield Under the decorative panel;
6. Inside the front bumper, pay attention to waterproofing;
7. Under the wiper board, pay attention to waterproofing.
Note: If blocking The wind glass is pasted with a metal thermal insulation layer or a heating layer, which will reduce the GPS reception signal and cause the GPS to work abnormally. At this time, pay attention to changing the installation location of the device.
Installation Points
1. In order to avoid damage by thieves, the location of the equipment should be as concealed as possible;
2. Avoid contact with the emission source Put together, such as wireless reversing radar, anti-theft device, and other in-vehicle communication equipment;
3. It can be fixed with a cable tie, or can be pasted with a wide sponge strong double-sided tape;
4. There are GSM antennas and GPS antennas in the device, and the front side should be up (to the sky) when installing.