1. How to clean the ATVs
The ATVs have been running in various complex terrains for a long time, with great loss. After a long journey, they are full of mud The stained ATV gives a bad feeling visually. A complete cleaning can not only restore the clean and domineering appearance of the ATV, but also facilitate the storage of the vacant time. The following is a brief introduction to the cleaning of the ATV. method.
1. It is best to wash your car yourself. Many players like to go to the car wash shop. In fact, the car wash shop seems to have complete tools and standardized operation, but the truth is that the efficiency is the priority and the effect is the second, so in this case It may cause the spark plugs and various circuits to fail.
2. When cleaning the ATV, be sure to turn off the flame first, and clean all parts after cooling down completely. Because if you rashly use cold water to directly clean the ATV, due to the principle of thermal expansion and cold contraction, it is very easy to damage the oil seals in various parts, resulting in engine oil leakage or oil seepage, which will also cause the exhaust pipe to be chrome-plated at the engine connection. Fall off oxidation rust.
3. When washing the car, be sure to clean the lower part of the engine and the heat sink, and use more brushes stained with cleaning fluid to clean. This cleaning method is not only more refined, but also can detect engine leakage in time oil, etc.
4. It is best not to wash these parts directly with water, for example, headlights, left and right armrests, switches, exhaust pipes and exhaust ports (best plugged with something), horns, spark plugs, air filters , battery, etc., because these parts have circuits, if they are wet, it may cause a short circuit or leakage, the lights do not turn on, the horn does not sound, the fire does not fire, and the driving is weak. It is best to wipe with a rag, or you can use a steam or vacuum cleaner to clean, and then use a dry rag to wipe the key parts.
Second, the maintenance method of beach motorcycle
1. Air filter, carburetor, oil filter and fuel switch must be cleaned every month examine.
2. Check the cable connectors of the whole vehicle to see if they are in good condition.
3. The vehicle must be kept clean and tidy from time to time. After cleaning the vehicle, a start-up inspection must be carried out. The side stand should run at an idle speed for 5-10 minutes, drain the water in the exhaust pipe, and then start the road at a medium speed. Drive for a few minutes or dry in the shade, not in the sun.
4. When the vehicle is parked for a long time, clean the gasoline in the carburetor room, remove the battery and store it after charging. It is best to charge the battery once a month.
5. Check and adjust the clutch, check the control parts of the accelerator and brake, and add lubricating oil to the cable.
6. For oil replacement, the time point is generally, the first oil change after driving about 1000 kilometers or 20 hours, the second oil change is about 5000 kilometers or 100 hours, using a motorcycle engine oil. (It is best to discharge the engine oil when the engine is hot, so that the cleaning is more thorough. Vehicles used in alpine regions in winter should be replaced with oil suitable for alpine regions.)
7. If it is driven by a chain, use The chain should be kept clean to avoid friction and damage to it by sand and sand, and lubricating oil should be injected at the same time.
8. When it rains or snows while riding, after parking the car, be sure to dry the car, especially the exhaust pipe, because most of the rainwater is acidic and the exhaust pipe is corroded Most of them are caused by these reasons.
Only proper maintenance and maintenance can prolong the service life of the ATV and reduce a lot of maintenance costs, so daily maintenance and maintenance are very important and must not be ignore.
