How to connect the water inlet pipe of the washing machine to the faucet
1. First, wrap a few circles of raw rubber at the outlet of the water inlet pipe of the faucet, which can prevent the water from leaking when the faucet comes out.
2. Loosen the base under the steel head, and then use a screwdriver to loosen the four screws on the steel head.
3. After installing the steel head to the center of the faucet, tighten the screw with a screwdriver, and then tighten the base under the steel head by hand.
4. Insert the steel head into the water pipe connected to the washing machine, and then install the other end of the water pipe to the water outlet of the washing machine.
How to deal with the leakage of the water inlet pipe joint of the washing machine
1. First, let’s check whether the water pipe of the washing machine is tightened. If not, we will tighten the joint This solves the problem of leaking water pipes. It is recommended not to operate with bare hands when tightening the joint, because the strength of the hand cannot make the joint well tightened, and certain tools are required.
2. If the water inlet pipe is damaged, in this case, it may be corroded by moisture for a long time, and then the water inlet pipe joint is corroded. If you don’t know that the water inlet pipe will leak, we can replace the water inlet pipe directly.
3. It is also possible that the water-stopping tape is damaged and causes water leakage. In this case, we only need to use a wrench to remove the faucet of the washing machine, and re-roll a new water-stopping tape here. That’s it.
How to unblock the water inlet pipe of the washing machine
1. You can use iron wire to unblock it
Prepare a slender iron wire, make sure that there are A certain hardness, so that it can pass through the blockage better. Tie a rag behind the wire and fix it well, so that the wire goes in from one end of the water inlet pipe and goes out from the other end, and the rag at the back will remove the blockage. out.
2. You can use a solvent to dredge
One end of the water inlet pipe is blocked, some solvent and hot water are poured into it, the other end is also blocked, and then shake a few times, Make sure that the dissolving agent can reach every part of the inner wall, wait about ten minutes, you can untie the port, pour out the dissolved dirt inside, and rinse it with clean water several times.
Why the washing machine does not feed water
1. The water inlet valve filter is blocked
It is possible that the washing machine does not feed water It is caused by blockage. This blockage is usually at the filter screen. Because the washing machine uses tap water, a filter screen will be installed at the inlet valve position to intercept water impurities. The filtering process does not deal with impurities, which takes a long time. There will be more and more impurities, which will naturally form a blockage, just remove it and clean it.
2. The water inlet solenoid valve is faulty
The water inlet of the washing machine is controlled by the water inlet solenoid valve. If it is not good, it will not be able to enter the water. It is necessary to contact a special person to come to repair it. It is best to replace the solenoid valve.
