LED ceiling light installation tools
Impact drill, electrician’s pliers, screwdriver (torx or flat-blade screwdriver, depending on the screws on the light), insulating tape, a small piece of Wooden strips, ladders (preferably wooden ladders, because wooden ladders can insulate and prevent conduction).
Installation method of LED ceiling light
1. Unpack the package, and first remove a little thread that comes with the base.
2. Take out the lamp (ceiling lamps generally have their own light source).
3. Put the base on the position and draw the position of the hole.
4. Drill holes on the ceiling according to the installation holes of the ceiling light.
5. Inject colloid in the place where the eye is drilled to fix the screw.
6. Put the base up, turn it at an angle, and tighten the screws.
7. Wiring (connect the wires carefully to avoid loosening in the future).
8. Reinstall the lamp tube (you can test whether the lamp will turn on at this time), and then cover the lamp cover.
Precautions for installation of LED ceiling lights
1. When installing ceiling lights in masonry structures, pre-embedded bolts should be used, or expansion bolts, Secure with nylon or plastic plugs; do not use wooden wedges. And the bearing capacity of the above-mentioned fixing parts should match the weight of the ceiling lamp. In order to ensure that the ceiling lamp is fixed firmly and reliably, and its service life can be extended.
2. When using expansion bolts to fix, the bolt specifications should be selected according to the technical requirements of the product, and the drilling diameter and embedment depth should be consistent with the bolt specifications.
3. The number of bolts for fixing the lamp socket should not be less than the number of fixing holes on the base of the lamp, and the diameter of the bolts should match the aperture; lamps without fixed mounting holes on the base (drill holes by yourself during installation) , the number of bolts or screws used for fixing each lamp should not be less than 2, and the center of gravity of the lamp should be consistent with the center of gravity of the bolts or screws; only when the diameter of the insulation table is 75mm or less, only one bolt can be used or screw fixing.
4. LED ceiling lights cannot be directly installed on flammable objects. Some families use painted three plywood to line the back of the ceiling lights for aesthetics. In fact, this is very dangerous, and heat insulation measures must be taken. ; If the high temperature part of the lamp surface is close to combustibles, heat insulation or heat dissipation measures should also be taken.
5. Before installing the LED ceiling lamp, it should also be checked: ① The cross section of the wire core leading to each lamp, the copper core flexible wire is not less than 0.4mm2, and the copper core is not less than 0.5mm2, otherwise the lead must be replace. ②The connection between the wire and the lamp holder and the connection of the parallel wire between the lamp holders should be firm, and the electrical contact should be good, so as to avoid the danger of sparks between the wire and the terminal due to poor contact.
