1. How to install the multi-function tiller
In daily farming use, we don’t know how to install the multi-function tiller after receiving it. Now I will give you a brief introduction The installation steps of the main unit of the multi-function tiller are given below to lay a solid foundation for the actual operation.
1. Open the box of the main unit of the multi-function tiller, take out the tires, unpack the tiller, and lift it out of the machine. Install a tire on both sides of the main engine. Note: If there is a lot of rotary tillage work, turn the “her” character on the tire toward the direction of the engine. If you use a lot of mowing, turn the word “person” in the opposite direction of the engine.
2. Remove the long white bolts that fix the handrail of the multi-function tiller, then lift the handrail, and then install the bolts so that the bolts pass through the screw holes on the handrail, and then lock and fix .
3. Lift the armrest by screws, and re-install the long bolts so that the bolts pass through the mounting holes above.
4. Hang the rotary tiller at the position below the screw, and then fasten the two bolts to lock the nut.
5. Pull up the steering handle (the steering handle is on the left armrest, hold the armrest with your left hand, pull up the black handle with your right hand, and turn the armrest gently when it forms a 60-degree angle with the armrest), Turn the handrail direction 180 degrees. Then place all the wire harnesses to the right side, then align the green cover with the three mounting holes, and install it by pressing it lightly with your hands. The handle starts to rotate.
6. Install the dust cover to the 3 holes reserved for the handle.
Second, how to use the multi-function tiller
1. When the operation starts, the multi-function tiller should be in an elevated state, and the power output should be combined first. shaft, increase the speed of the cutter shaft to the rated speed, and then lower the rotary tiller, so that the blade gradually penetrates to the required depth. It is strictly forbidden to combine the power take-off shaft or drop the rotary tiller sharply after the blade is buried in the soil, so as to avoid bending or breaking the blade and increasing the load of the tractor.
2. During the operation, the speed should be as low as possible, which can not only ensure the quality of the operation, make the clods finely broken, but also reduce the wear and tear of the machine parts. Pay attention to whether the multi-function tiller has noise or metal percussion sound, and observe the broken soil and deep tillage. If there is any abnormality, it should be stopped immediately for inspection, and the operation can be continued after it is eliminated.
3. When the headland turns, it is forbidden to operate. The multi-function tiller should be lifted to keep the blade off the ground, and the tractor throttle should be reduced to avoid damage to the blade.
4. When reversing, crossing ridges and transferring fields, the multi-function tiller should be lifted to the highest position, and the power should be cut off to avoid damage to the machine parts.
