How to use the hydraulic punching machine
1. Connect the oil pump and the working head with a quick connector.
2. Select the corresponding upper and lower molds, first install the upper mold and then install the lower mold. When installing the upper mold, unscrew the positioning screws to a certain position and then install the lower mold. Be sure to put them in place. Tighten the set screw again to work.
3. Put the workpiece away, close the oil return screw of the oil pump, and move the handle until the oil return screw is loosened after the work is completed. The middle of the tripod and the workpiece, otherwise the workpiece will be stuck on the mold.
Operating Specifications for Hydraulic Punching Machines
1. Operators must be trained in safety technology, and only qualified persons can take up their posts.
2. The moving parts on the machine will exceed the range of the machine base and feet when moving. When the machine is running, no one is allowed to enter the above dangerous area.
3. When the machine is going to work, the operator’s hands cannot be placed near the die and on the moving platform. The unloading height of the platform shall not exceed 10 cm.
4. During the operation of the machine, it is not allowed to overhaul and adjust the mold.
Hydraulic punching machineMold replacement method
1. Upper mold replacement method: use a (black) elastic screwdriver Loosen the fixing bolt of the die (silver white) to the left, slowly remove the upper die, replace the desired upper die, and then tighten the upper die fixing bolt to the right with a screwdriver.
2. Lower die replacement method: use a small hexagonal wrench to loosen the screw that fixes the lower die to the left, and then use your fingers or small tools to push out the lower die from bottom to top. , Replace the lower die matched with the upper die, and tighten it with a small wrench.
Note:
1. The typing side of the die should face up and not down.
2. When replacing the mold, remove the upper mold first, so as to replace the lower mold.
