How to use the bean sprout machine at home
1. Method Soak the beans in warm water of about 45-60 degrees for about an hour. Soaking beans in warm water is to screen out bad beans or bad beans, and is an important part of cultivating high-quality bean sprouts. Soak mung beans for about half an hour, soybeans for about an hour, and red beans and black beans for about two hours because of their thick skins.
2. Put the selected soaked beans into the plastic screen of the bean sprout machine, and lay them flat to cover the bottom of the screen. It is not advisable to put too many beans.
3. The water tank of the bean sprout machine is filled with water close to 2/3 of the total capacity, put the cultivation plastic screen on the water tank, insert the pipe, install the leaves, and cover the transparent cover. After the power is turned on, the switch of the bean sprouts machine is turned on, the water pump is started, and the sprinkler blades begin to rotate and sprinkle water.
4. Put the bean sprout machine in a cool and dark bedroom, kitchen, storage room or basement. It is best to cover the lid with a dark cloth or towel with good air permeability to block the light and make the bean sprouts better. growth.
5. Change the water in the water tank of the bean sprout machine once a day. When changing the water, turn off the power supply, remove the transparent cover, and remove the plastic screen where the bean sprouts are cultivated. Put back the plastic screen with bean sprouts, install the sprinkler blades, cover the transparent cover, plug in the power supply, and turn on the switch of the bean sprouts machine.
What should you pay attention to when using the bean sprout machine
1. The bean sprout machine can only be powered on after 2/3 of the water tank is filled with water. When changing the water, first unplug the plug and disconnect the power supply.
2. The water container must be kept clean, and the parts of the bean sprout machine must be cleaned after one sprout, especially the water pump inside. If the bean sprout machine is not used for a long time, be sure to dry the water of the bean sprout machine after cleaning it, so as to avoid the breeding of bacteria.
3. The container for water below and the container for beans above must be installed well, and there should be no skew, which may cause the water to not rise normally.
4. Too low or too high room temperature will affect germination. In winter, if the temperature is too low, you can choose to heat water, but heating water is definitely not boiling water, and the water temperature must be well controlled. In summer, the temperature is too high, and the sprouts are easy to rot, so the water should be changed frequently.
5. Do not use a kitchen rag to clean the bean sprout machine, because there will be oil on the kitchen rag, and the beans will easily rot when they touch the oil, so be sure to use a clean rag to clean the bean sprout machine.
6. If you want the sprouts to grow thicker, you can put a few small stones on the leaking net above the bean sprout machine to press it.
7. Soak some beans in a pot first, and let the beans send out some sprouts first. Put a part of the dried beans under the container for the beans first, and then put a part of the beans that sprout on top of the dried beans. In this way, the beans that sprout on the top can be eaten first, and when the top ones are eaten, the bottom sprouts can be eaten again.
8. The new beans of the year must be used to improve the germination rate. The water should be changed once or twice a day, once in winter and twice in summer.
Declare: The above methods are derived from the program system index or shared by netizens. They are for your reference only and do not represent the research views of this website. sex and authority.
