[The installation of the radiator pipe] The installation method of the radiator supervisor to install the radiator branch pipe
Installation of the radiator supervisor
When the radiator supervisor is systematically arranged, it should be coordinated with the usage requirements of the building, the heating system schema, and the arrangement of the radiator. Strive to save pipes and facilitate installation and maintenance.
The main pipe of the radiator pipe is usually installed in the surface. When it is installed in the surface, it should be arranged at the corner of the outer wall and the wall between the windows as much as possible. Before installing the main pipe, first place the radiator in place, and then install the riser after finding the straightness, so that the size of the main pipe can be accurate. The semi-circular bend on the double riser should be accurate and flat, and the branch pipe should be in the middle of the semi-circular bend, and it should not be wrong or wrong. After the pipeline is installed, check whether the coordinates, elevation, position of the reserved port and the diameter of the pipeline are correct, then find the straight line, check the slope with a level ruler, and after the adjustment is qualified, adjust the U-shaped clamp of the elevator bolt to make it tight Moderate, level and consistent, and finally weld the stop lever at the fixed clip.
Installation of radiator branches
When installing radiator branches, it is usually It will be in the form of concealed installation. The fork bend of the radiator branch pipe lamp for concealed or semi-concealed installation should be adapted to the corner of the radiator groove in order to achieve a beautiful effect. The branch pipe connecting the radiator should have a slope. The upper and lower water supply branch pipes are sloped to the radiator, and the return water branch pipes are sloped to the riser; The water supply branch pipe slopes toward the radiator, and the return water branch pipe slopes toward the main pipe.
The radiator branch should be installed after the radiator and riser are installed, or at the same time as the riser. When the radiator branch pipe passes through the wall, in addition to adding a casing, it should also be noted that the branch pipe cannot have a joint in the wall. When installing the valve on the branch pipe, the side near the radiator should be connected with the detachable part. When installing the radiator branch pipe, be sure to adjust the steel pipe properly before meeting each other to avoid skewing the branch and the riser.
