[Repair of plastic sealing machine]Fault repair of plastic sealing machine Common faults and maintenance of plastic sealing machine
1. The effect of plastic sealing is poor, and it cannot be glued.
The setting gear of the machine is inconsistent with the thickness of the plastic sealing film used, resulting in low temperature. Solution: Refer to the machine prompt label to select the corresponding plastic film and gear.
2. There are bubbles or wrinkles after plastic sealing
The plastic film used is thin, and the temperature of the plastic sealing machine is set. The setting is too high
Solution: lower the temperature of the machine, and then start to use the ready light when it turns on.
3. The green light keeps flashing, and the machine cannot heat the plastic sealing machine Damaged heating appliance
If this fault occurs, it needs to be repaired by professional maintenance personnel.
4. The machine is powered on but cannot pass the film
1. There are foreign objects stuck inside the machine
Use cleaning paper to clean the machine, if there are not many foreign objects roll out. If it cannot be cleared, it needs to be sent to a professional repair shop for repair.
2. The transmission gear is damaged 3. The motor is faulty. > 5. The Ready light keeps flashing
1. The heater is damaged, or the thermal fuse thermistor is damaged.
2. The machine will also flash when it cools down from high temperature to low temperature. This process is relatively long, depending on the ambient temperature. It takes about 5-10 minutes to recover at normal temperature.
6. Loud noise
1. Because the plastic sealing machine has been working at high temperature for a long time, the lubricating oil of the transmission gears of various parts is worn out. The sound of gears rubbing.
Regular maintenance, high frequency of use should be once a month. 2. The deceleration transmission sound from the fast motor
This phenomenon is characteristic of the motor and is a normal phenomenon. There will be some relief in low speed operation.
