I. Soymilk machine failure phenomenon: Beans can not be broken failure
Many users often find that the soymilk machine makes a The taste of soy milk is not good and it is relatively rough. At this time, many people will attribute this phenomenon to the quality problem of the soy milk machine.
As everyone knows, this is a phenomenon caused by a small fault in the soymilk maker. When this kind of failure occurs, it is generally considered that there is a problem with the filter screen of the soymilk machine.
Solution:
If the mesh of the side mesh or bottom mesh of the mesh cover is dry and blocked, then the soymilk produced by the soymilk machine will be rough and the particles will be large. . This is to disassemble the soymilk maker, immerse the mesh cover in boiling water and add detergent, soak it for about 15 minutes and wash it with a cleaning brush. Most of these failures are caused by the user’s failure to clean the soymilk maker during normal use.
For some meshless soymilk machines, there will be no mesh cover clogging failure. At this time, it is mainly considered whether the voltage is too low when the soymilk machine is in use, or too many beans are put in, exceeding the limit. The capacity of the soymilk maker. This situation is caused by improper operation of the user, and it can be solved only by changing the operation method.
2. Soymilk machine failure phenomenon: burning failure
Solution:
The soymilk machine has burning phenomenon, generally It will be considered that there is a problem with the soymilk machine and it can no longer be used. In fact, when the soymilk machine burns, it may be cleaned with the heating tube of the soymilk machine. At this time, the heating tube of the soymilk machine needs to be cleaned.
In addition, if using mung bean alone to make soymilk, this kind of failure may also occur. At this time, it is best to add peanuts or soybeans to make it together to solve this problem.
Three, Soymilk machine failure phenomenon: overflow failure
Solution:
In the process of making soymilk, the benefits of soymilk, It can be found everywhere. This kind of situation is relatively common. I believe many people have encountered it. In fact, it is mainly due to the following reasons:
1. The mesh of the mesh cover is blocked. Clean.
2. The anti-overflow electrode is not cleaned. Treatment method: Clean the anti-overflow electrode.
3. Add too much water, treatment method: Please add water to between the upper and lower water level lines.
Fourth, soymilk machine failure phenomenon: undercooked, alarm failure in advance
Solution:
It is obvious that the soymilk is not cooked However, the soymilk machine alarmed and reminded in advance that such a failure was not only caused by the soymilk machine itself, but also because of incorrect operation.
For example, if the beans have been soaked in water for too long and have deteriorated, the safety identification function of the soymilk maker will issue a safety alarm function to remind the user. Or because too much water is added, the load of the soymilk machine is exceeded, and the soymilk machine cannot work. Therefore, when using the soymilk maker, it is best to add water between the upper and lower water level lines so that the soymilk maker can operate normally.
