1. The indicator light of the electric grill
does not light up
Maintenance method:
1. The power plug and socket are in poor contact, and the plug and socket should be replaced or repaired.
2. If the core of the power cord is broken, the power cord can be replaced.
3. The thermostat contacts are burnt, repair or replace the thermostat.
4. The contact head of the timer is in poor contact, repair or replace the contact head.
Second, the electric grill does not heat up
Maintenance method:
1. Check whether the indoor power supply is powered off.
2. Check whether the power cord of the electric barbecue is disconnected, and whether the power plug and socket are in poor contact. Find the broken wire and reconnect it, and wrap it with insulating tape. If the plug or socket is damaged, replace it with a new one.
3. Check whether the heater is loose and whether the contact between the heater and the socket is good. It is a bad connection, please reconnect it. If the damage is serious, replace it with a new one.
4. The heating wire is blown. Replace with new products of the same specification.
5. The switch contacts of transfer switches, thermostats and timers lose elasticity; the contacts are severely ablated or have poor contact. Find damaged parts for repair or replace with new ones of the same specification.
Third, the temperature controller of the electric grill is out of order
Repair method:
1. The thermostat contacts lose their elasticity or the contacts are bonded. Replace the contacts that have lost elasticity or re-grind the contacts with a fine emery cloth.
2. The shaft threaded sleeve rotates with the shaft, and the position of the fixed contact piece cannot be adjusted. Fixed threaded sleeve.
3. The ceramic beads on the bimetallic sheet are damaged or fall off, so that the bimetallic sheet does not reach the moving contact piece. Replace the bead or tighten the bead.
4. The bimetal is damaged. Replace with new products of the same specification.
Fourth, the timing switch of the electric grill is damaged
Repair method:
1. Contact ablation or bonding. Sand carefully with fine-grit sandpaper.
2. The moving spring is weak, replace it.
3. If the clock spring or gear is damaged, replace the damaged parts.
5. The door of the electric grill is stuck or not closed tightly
Repair method:
The furnace door is stuck mainly because the door bead protrudes too much from the spring box and cannot be retracted when it is stuck. Readjust the door bead.
The main reason is that the spring is weak and loses its elasticity, so replace it with a new spring.
Six, the glass of the electric grill door is damaged
Repair method:
The main reason for this failure is that the compression screw is too tight, or the glass door is drenched in cold water during high temperature baking.
Use heat-resistant glass to replace it according to the original specification, and avoid the above situation when using it again.
Seven, electric grill leakage
Maintenance method:
1. The sealing insulation material of the heater is subjected to high temperature to reduce its insulation performance and cause leakage, and re-sealing.
2. There is conductive dirt on the heater socket to reduce its insulation performance. Wipe off the conductive dirt with a dry cloth.
3. The insulation performance of the transfer switch, heat preservation switch or timer switch will be reduced due to moisture, and should be dried.
4. If the insulation layer of the deep wire or plug is damaged, replace it with a new one.
5. The loose wire head touches the shell, and the loose wire head is connected.