1. What is the construction method of the canopy
 tent?
In the city, the heart is in the wilderness. Together with friends and colleagues, set up tents by yourself, cooperate with the ‘Little Enclosure Experts’ canopy, and then pack picnic food to enjoy the time of hiding in the wild, temporarily isolated from the city.
The three-piece set is indispensable for going out camping: tent, sky curtain, table and chairs. The combination of these three is always exciting. What is the method of building a tent?
1. The first method: 2 canopy poles
The middle hole on the short side of the curtain is supported by two canopy poles, and the four corners of the curtain are supported by two canopy poles. Use the wind rope to pull down and fix at 45 degrees respectively, the sky curtain is in the shape of a roof ridge, and the two roof rods in the middle should be kept on the same line as the roof ridge line.
2. The second method: 4 canopy poles
Nail the two corners of the short side of the canopy directly, and then the long side The middle hole and the other end of the hole are supported by a canopy pole. After the middle hole is supported, the projection position needs to be close to the grounding hole. Finally, it is fixed with a wind rope to make the side of the canopy look like a figure 7. This is done. Such a space is more secure, more like a comfortable living room, and the hanging curtain can also double as a projection function.
3. The third method: 1 canopy pole
The corner of the canopy should be nailed first, and the opposite corner should be built with canopy poles or camping poles. Hold the column up, use the wind rope on the opposite corner to pull it at 45 degrees, and hit the ground nails at the remaining two corners. This way of setting up makes the canopy closer to the tent, and can play a better effect of sheltering from wind and rain. The two corners on the same side of the canopy are supported by canopy poles, the wind rope is also pulled down at 45 degrees, and the other side of the canopy is fastened with two ground nails. This way of building can well block the wind and sunlight from one side of the sky, and the effect of blocking wind and shading is very good.
4. The fourth method: 2 canopy poles
The two corners on the same side of the canopy are supported by canopy poles, and the wind rope is also Pull down at 45 degrees, and use two ground nails on the other side of the canopy. This way of building can well block the wind and sunlight from one side of the sky, and the effect of blocking wind and shading is very good.
5. The fifth method: 1 canopy pole
First use ground nails to make the middle end of the canopy, and use the canopy pole to support the opposite end Get up, pull the wind rope at 45 degrees, put ground nails in the middle of both sides, and fold the excess parts. This way of setting up can even replace a tent.
Second, Introduction to the method of tying and knotting the rope of the canopy tent
The previous article introduced five methods of building the canopy. In the construction of the canopy, the method of tying and tying the rope of the canopy tent is particularly important. There will be such a three-hole slider on the windproof rope. The one end of the slider is knotted, and the other end that is not knotted is the non-scribed end. The specific steps are as follows:
1. Insert the non-sliding end of the windproof rope into the grommet of the tent, tie it tightly, and then start to adjust the sliding end.
2. Pull out the loop rope near the end of the rope in the slide, and cover the ground nail.
3. Select the location of the ground nails according to the ground conditions. Generally speaking, the smaller the angle between the windproof rope and the ground, the better the wind resistance of the tent.
4. Insert the ground nail into the ground at an oblique angle of 45-60 degrees, at least drive 2/3 of the ground nail into the ground, so that the maximum force will be exerted.
5. Tighten the front end of the windproof rope with one hand, and push the three-hole sliding piece toward the tent end with the other hand. Tighten hard, the tighter the better.
6. Release your hand, if the whole wind rope is still very tight, it means the wind rope setting is complete. If it is found to be loose, continue to tighten it according to the above method.