What should I do if the steam iron leaks?
1. Just add water, but the power is not turned on, the water flows directly from the chassis, please check whether the steam knob is at “0” gear.
2. Just start ironing, turn off the steam knob when the indicator light is on. If the temperature is not enough, the water is not enough to atomize. Check whether the plug is plugged in properly. If the plug is not plugged in properly, because the indicator light is also off, the temperature is not enough, and the water cannot be heated into steam, so press the spray button and water will leak from the steam hole.
3. If it leaks after adding water, check if the steam button is turned off before adding water. For a steam iron, the steam button must be turned off before adding water.
4. The steam iron has a drip switch on the front of the handle. Press it once to drip water onto the ironing board. When the temperature is high enough, the water evaporates into steam and sprays out from the bottom hole. If the temperature of the ironing board is too low, the water cannot Evaporation will cause water leakage, and it will not leak if you press it again to turn off the water.
Why does the steam iron leak water
1. Insufficient temperature
If the temperature is insufficient, the water It may not meet the conditions of sufficient atomization. You should check whether the plug is plugged in properly. If the plug is not plugged in, the indicator light will also be off. The temperature is naturally not enough, and the water cannot be heated into steam. You can press the spray button and there will be water. leaked from the steam hole.
2. The temperature rotation gear is wrong
This problem is easy to solve. During use, first adjust to the appropriate gear i, so that it can be naturally spray, and then slowly adjust the temperature knob. When using the steam spray function, you need 3 or more gears. Because the low temperature is not high enough, the water cannot be atomized into steam, which may cause water leakage
3. The timing of pressing is wrong
The spray button can be pressed normally when the temperature control indicator light is off; when the indicator light is on, if the spray button is pressed, the water It will not be atomized, directly causing hot water to leak from the bottom.
4. The pressing interval is wrong
When using steam spray, the interval of pressing the spray button should be no less than 2 seconds. You can press the button only after it is extinguished. The specific reason is given in the sermon above. If the hot water is not atomized into steam, it will flow out from the bottom plate, so be careful.
5. The water reservoir is too full
Because the water reservoir is too full, leakage will occur. Increase the temperature to eliminate water leakage and steam leakage.
6. Water valve wear
To control the water leakage caused by the wear of the steel wire in the water valve, you can replace the new steel wire of the same specification first. If the fault is still not eliminated, it may be that the hole in the ceramic body is worn. The valve can be removed, and the inner hole of the ceramic body can be carefully ground with emery, so that the diameter of the inner hole can be adapted to a new wire with a larger size, so that it can slide up and down without leakage. prevail.
Declare: The above methods are derived from the program system index or shared by netizens. They are for your reference only and do not represent the research views of this website. sex and authority.
