[What should I do if the wooden bathtub leaks] What should I do if the wooden tub is cracking and leaking?
I. What should I do if the wooden bathtub is leaking?
Simple seepage
If there is no large leak, just a small amount of water seeps.
You can turn the barrel upside down, and then tighten the iron hoop below it.
Tighten it a bit and see that there shouldn’t be too much water coming out.
Be careful not to overtighten.
Tung oil can be applied to a small amount of water leakage
Generally, after the barrel is made, a layer of oil will be applied to protect it from water leakage and beauty.
If there is a small amount of water leakage from the barrel, you can apply tung oil on the barrel, and the effect is good.
Be sure to let it dry before soaking in water.
The newly bought wooden bath tub leaks and can be treated with water
If it is a new tub, it may be Because there is no moisture for a long time, and there is no maintenance, it will leak some water.
When you use it for the first time, fill it with water. After 12 hours of soaking, the wooden barrel is completely soaked. At this time, there should be no water leakage.
If there is still water leakage, you should contact the manufacturer.
Second, what to do if the barrel is cracked
You can find some sawdust ash, and then use a knife to slowly remove the sawdust ash in the place where there are gaps Plug it in, being careful not to push too hard, so the gap will be bigger. Slowly put the sawdust into the gap, and then stick it with all-purpose glue.
Specific steps
1. Drain the water in the barrel completely.
2. When there is no water in the seam, clean it up. Note: Make sure there is no water in the seam;
3. Fill the seam with light white sawdust;
4. Slowly dip the 502 glue into the seam
5. After about 10 minutes, fill in the sawdust again, and then immerse the glue into the seam again;
6. If there are burrs on the repaired surface, please use Sand lightly with sandpaper, be careful not to sand on other wood, so as not to damage the paint film;
7. Dust the repaired surface and paint twice with a brush;
8. After 24 hours (the paint is completely dry), you can put water for testing. If the leak still occurs in some places, use the above steps again.
Note: When handling, please be careful not to put the glue on the skin.
Three, anti-cracking and water leakage strategy for wooden barrels
The wood for making wooden barrels is dried at high temperature, and the moisture content of the wood is controlled at 12% about. However, due to regional differences and differences in the use environment, northern users need to carry out some basic maintenance during the use process. Southern users do not need it.
1. Consumers should pay attention from the first day they are purchased. After the barrel is delivered to the home, consumers should check the quality again: whether there are cracks, whether the steel wire at the connection is loose, whether the material is consistent with the selected sample, etc. Consumers should also note that most of the newly bought wooden barrels will be coated with a layer of tung oil, and its smell tends to last for a long time, so be sure to keep the bathroom ventilated and open the windows regularly for the first few days. Change the air so that you don’t fill your home with pungent odors.
2. There will be water seepage in the initial water test, which is a normal phenomenon. After the water is full, it should be soaked for more than 12 hours to fully infiltrate the wooden barrel. At this time, the water seepage of the wooden barrel will stop. If you have any questions, please contact the manufacturer in time.
3. Use it every day or once every two or three days. After taking a bath, drain the dirty water in the bucket and rinse it with clean water.
4. Because the wood itself will expand and contract with heat, it is not allowed to be directly exposed to the sun or to be blown by cold wind. If it is not used for more than 2 months, the wooden barrel can be wet and sealed with a large plastic bag , to prevent the air from taking away moisture
5. It is usually best to put a little water to absorb moisture and keep the wood saturated and moist. But don’t use too much water, because the bathroom itself has a certain humidity. Be careful not to use the dirty water after bathing, in order to avoid the wood to absorb sewage and accelerate aging or produce mildew.
6. After the barrel is used for a period of time, the fixed iron wire outside the barrel will be loose. At this time, the barrel can be turned upside down, then the iron wire can be tightened, and hot water can be added to continue to use.
7. When buying wooden barrels, it must be in a large shopping mall or building materials city. Because the wooden barrel is different from other consumer goods, its service life is about 5 to 10 years, and it often needs professional repair and reinforcement. Therefore, you must choose a merchant with good quality and guaranteed after-sales service to buy it. Which brand of bathtub is good? The top ten brands of wooden tubs >>
8. The thickness of the wood of the wooden barrel wall will be different. Generally, the wooden barrel with the thickness of the barrel wall between 2 cm and 3 cm is selected, and the thermal insulation effect is the best. .
