What should I do if the geothermal filter is clogged?
If the geothermal filter is often blocked, it is recommended to install a pre-filter on the water inlet pipe, because the pre-filter is It is easy to disassemble and wash, and it is safe and convenient. As long as it is cleaned regularly, the filter will basically not be blocked.
When do I need to clean the floor heating filter
1. The floor heating filter needs to be cleaned almost every year, and the specific cleaning times should be based on the specific actual situation Come to decide, for example, during the heating process, it is found that the temperature of the home is quite high, but it is slowly getting lower and lower. At this time, the filter of the floor heating should generally be cleaned. Under normal circumstances, in a heating period, it is advisable to clean the heating filter twice.
2. In addition, after cleaning the floor heating pipes at home for two or three days, the filter generally needs to be cleaned. In addition, if the heating starts to heat up in the first year and then does not heat up, then the Underfloor heating filters may need to be cleaned many times, due to the relatively high amount of impurities in the newly heated pipes.
How to clean the geothermal filter
1. Take the filter on the main water supply pipeline in front of the sub-catchment at home as an example, the first tools to prepare It is an adjustable wrench or an open-end wrench, and the size should match the filter. Prepare a water-receiving basin to prevent water from splashing on the ground or on the cabinet when the filter is blocked.
2. After preparing the tools, you can start the operation: first put the prepared basin or bucket under the filter in front of the sub-collector, and then close the water supply pipe in front of the filter. The valve of the filter and the valve on the water supply pipe of the filter (it can also be the loop control valve of the sub-catchment), then use a wrench to twist the filter plug counterclockwise, and gently unscrew a few threads at the beginning, as long as the filter has The water can flow out, and then use a basin or bucket to collect the water until no water flows out of the filter; finally, we can remove the wire plug of the filter and take out the filter screen in the filter.
3. After taking out the filter, first clean up the debris in the filter, then take the filter under the tap of tap water to rinse it clean, check the holes of the filter, and ensure that there are no holes in the filter. In any blocked position, when it is found that the holes of the filter screen are clogged a lot and cannot be cleaned, we need to replace the filter screen.
4. After the filter is cleaned, install the filter into the filter, screw the plug on by hand, and then use a wrench to tighten the plug in a clockwise direction. Now, open the previously closed valve, and check that the plug is not leaking, which means that the cleaning of the filter is complete.
5. In addition, the filter in the pipeline well should also be cleaned by the same cleaning method. When cleaning the filter, it is recommended that the two filters must be cleaned at the same time, not just one. If only one is cleaned, then the effect may be small.
Filter performance characteristics
1. The internal structure of the filter is special, it is manufactured by the filter disc filtration technology, and its performance is accurate and sensitive. It is ensured that only the particles that meet the requirements can enter the system, and each user can choose the exact different filter according to the water needs.
2. The service life of the filter will be relatively long. It is made of new plastic, and its components are not only strong, but also have the characteristics of wear resistance and corrosion resistance. There will be no wear and tear for about 10 years, and the filtering effect will not change over time.
3. The filter has the characteristics of high quality and less maintenance. It conforms to the relevant quality standards of our country, and has been tested and operated by simulation before leaving the factory. In the process of use, it only needs to be tested regularly, and there is no need for additional daily maintenance.
4. The filter uses standard modules, which can effectively save space, and users can choose flexibly according to their own needs.
