1. How to add ink to color ink cartridges
1. Peel off the label on the upper part of the ink cartridge, and see that there are five small holes under the label.
2. To distinguish colors, one hole is red, two holes are blue, and two holes are yellow (you can use a toothpick to insert a small hole to distinguish the color).
3. Put a good tissue under the print head, which does not drop paper scraps, so as to prevent the ink from smearing from the nozzle; The color of the nozzle part can follow this method).
4. Insert the needle into the small hole for ink injection, and inject an appropriate amount of ink.
5. Wipe around the holes and label them.
Second, Canon816How to refill color ink cartridges
1. Gently peel off the sticker on the top of the cartridge. Be careful not to damage it. After adding ink, you have to paste it back.
2. After tearing off the sticker, you will see a line like an earthworm, which is a ventilation slot, which is linked with three ventilation holes (815 ink cartridge has only one ventilation hole, 816 has three.) In the figure, the boxes are marked with three colors. The top hole is red ink, the lower left corner is blue ink, and the lower right corner is yellow ink.
3. Drilling, all three holes should be drilled. Don’t drill too big. If you have drilled, you don’t need to drill repeatedly.
4. Ink color and corresponding hole, insert 1-1.5cm, and inject 2-3ml.
5. Finally, paste the sticker that was torn off in the previous position, and keep the tail of the earthworm-shaped ventilation groove outside, otherwise it may affect the printing.
6. Finally, put the ink cartridge back into the printer. After adding ink, it is best to wait an hour before printing to allow the sponge to fully absorb the ink. If the ink output is abnormal or the nozzle is blocked, you can clean it two or three times with the cleaning nozzle program that comes with the printer, and deep cleaning can be done if necessary.
Notes
Three holes, you take a toothpick to insert and pull out to detect the color. Add according to the corresponding color. Add ink not more than 10ML. More is useless. It is more appropriate to add a bottle of ink three to four times.
Three, how to add ink to ordinary printers
The first step: first peel off the sealing patch on the ink filling hole, and then use the bead push tool The thin end of the ink presses the steel ball in the refill hole into the box.
Step 2: Take off the rubber cap on the ink cartridge, put the nozzle of the ink cartridge into the short needle and press it tightly.
Step 3: First snap the nut into the top of the ink cartridge, then insert the ink cartridge into the ink filling hole, and screw the screw into the nut hole.
Step 4: Rotate the screw to slowly push the piston until all the ink is filled into the ink cartridge (Note: Two inks must be added at a time)
Step 5: Remove the ink cartridge, put the Place a new steel ball in the ink injection hole and lightly press the ball with the butt end of the ball push tool until it is flush with the orifice. Then stick the circular patch.
Step 6: Hold the ink outlet nozzle of the ink cartridge against the rubber key, and press the end of the ink cartridge firmly to make it snap into the protective clip.
Step 7: Remove the short needle of the empty ink cartridge, insert the nozzle of the ink cartridge into the rubber key hole, and press it tightly. Reverse the screw to make the piston bounce, inhale the ink 2-3 mm high, and then gently take out the ink cartridge.
Finally, remove the ink cartridge from the protective clip, wipe off the ink stains with a clean paper towel, and then install it for use. At this point, the whole process of ink filling is over, and your printer can start a new job again.
