How to set up a general tent
1. First choose a camp, after considering the wind direction and terrain, choose a flat place, and lay the tent’s inner tent on the ground (usually the inner tent, but there are also some who first put up the outer tent and then drill into the inner tent to hang the inner tent. The principle is to wear the layer of the tent pole), and put the accessories such as the nail bag and the pole bag wrapped with the tent first. aside.
2. Take out the folded tent poles, connect them well, straighten them one by one, and connect them into a long pole.
3. Put the long fiber poles into the tent’s battalion tube (also called pipes), and some double-layer tents are built-in, so hang the hooks on the fiber poles. There are several rods to be worn at the same time.
4. Insert one end of the fiber rod into the hole in the bottom corner of the tent or on the needle loop (some tents use needle loops, each with its own advantages), and then to the other end (diagonally), with one hand. Hold the pole, hold the bottom corner of the tent in one hand, slowly arch the pole, prop up the tent, and then insert the pole into the hole in the bottom corner or on the needle ring.
5. Finally, hang the external account, open the external account, and cover it on the inner account.
6. There are also some ropes on the outer tent, which are used to strengthen the tent. Generally, you can not pull it if there is no strong wind. If you are not worried, it is best to pull it up. Also use ground nails. Pull several ropes evenly and forcefully. .
Different types of Tent erection method
1. Triangular tent
(1) Lay the tent tent flat on the ground, flatten it and nail it along the bottom edge Nail down.
(2) Hold up the two poles from the tent, put on the isolation tube, and then put in the horizontal pole.
(3) Cover the tent jacket and knock down the pull studs of the jacket to make all the outer tents straight.
(4) Put the rain cap into the end of the pole, and put on the wind-resistant cable to complete.
Note: There is a space between the inner and outer tents of the triangular double-layer tent. This space should be maintained, and the inner and outer layers should not be ‘sticked’ together. This space can play a role in preventing rain and keeping warm.
2. Dome-shaped tents
(1) Lay the tent on the ground, nail down the four corners (some are hexagonal) You can stretch the tent pole and then nail it to the ground.
(2) Knot the two sets of canopy
rods (three sets for the hexagonal dome).
(3) Insert the tent poles into the tent support, insert one end of the two groups into the sleeve holes, and stretch the other ends of the two groups of poles at the same time, and then insert the other end after tightening. inside the hole.
(4) Lift the tent and shake it into shape to lay it flat on the ground and hit the ground nails. If you have a jacket, put on a jacket or a small rain cover and you’re done.
Tips for setting up tents
1. Set up tents on hard and flat ground as much as possible, and do not camp on river banks and dry river beds.
2. The tent should be located in a place with good drainage such as sand, grass, or cuttings.
3. At least there should be a groove, do not put it next to a stream or river, so that it will not be too cold at night.
4. The tent should face south or southeast to see the morning sun. Try not to camp on ridges or hilltops.
5. Count the number of tent poles, ground nails, ropes and supports before setting up the tent. After the camp is built, put the items that do not need to be put into the tent cover.
5. To prevent insects from entering, sprinkle a circle of kerosene around the tent.
What are the precautions for setting up a tent
1. The entrance of the tent should be leeward, and the tent should be kept away from the hillside with rolling stones.
2. To avoid flooding of the tent when it rains, a drainage ditch should be dug just below the edge of the tent roof.
3. The four corners of the tent should be covered with large stones. Air circulation should be maintained in the tent, and cooking in the tent should prevent fire.
4. Before going to bed at night, check whether all the flames are extinguished and whether the tent is firmly fixed.
5. The tents should be set up in sequence: first set up public tents. On the downwind of the camp, first set up a cooking tent, build a stove, boil a pot of water, and then set up a warehouse tent for storing public equipment and a camping tent on the upwind side in turn. When the tents for the whole camp are set up, the boiled water is boiled and ready to drink and start cooking.
6. Build a field toilet: choose to be slightly lower downwind of the camp and away from the river (at least 20 meters away). It is best to dig a rectangular soil pit with a width of about 30 cm, a length of about 50 cm and a depth of about half a meter, and put some stones and fir leaves in it. Surrounded by plastic sheets or packing boxes on three sides, fixed well, and the open side should be leeward. Get some sand and a shovel and a piece of cardboard. Bury the excrement and toilet paper with some sand after defecation, and cover the pit with a board to eliminate odor.
Declare: The above methods are derived from the program system index or shared by netizens. They are for your reference only and do not represent the research views of this website. sex and authority.