[Washing machine does not drain water]What should I do if the automatic washing machine does not drain water?
First check whether the adjusting rod nut on the drain valve is loose, and the tractor pulls Check whether the cable is loose with the drain valve, so that the retractor cannot pull the drain valve core away, causing no drainage.
If the fixing nut is not loose or the cable is not loose, the retractor may be damaged and the drain valve core cannot be opened, and the retractor should be replaced at this time.
It is also possible that there is debris in the drain valve or the drain hose is bent and deformed. In this case, first unscrew the valve cover of the drain valve and remove the debris.
The gap between the drain rod and the rubber valve becomes larger, as long as the gap between the drain rod and the rubber valve is properly adjusted.
Drain valve inner spring is too long or has lost its elasticity. Just replace the inner spring.
The damping of the moving iron core of the drain solenoid valve is too large or the suction force is reduced. Remove the rust and dirt in the solenoid or replace the drain solenoid valve.
If it is not resolved, the computer board may be damaged and the computer board should be replaced.
First check the safety switch, turn on the washing machine and switch the program to the dehydrating state, press the safety switch brake arm to the lowest level by hand or tools, if the computer board alarms and the digital tube displays “E1”, at this time The safety switch or computer board should be replaced.
If the brake arm of the safety switch can be dehydrated normally after pressing the brake arm with a hand or a tool, it means that the power-off distance of the safety switch is too low, and the safety switch should be replaced at this time.
If only the pulsator rotates and the inner barrel does not rotate during the dehydration state, check whether the tractor has separated the clutch pawl and the ratchet wheel. If not, the adjusting rod nut on the drain valve may be loose. and wear, resulting in insufficient opening distance. At this time, the distance of the adjusting rod should be re-adjusted so that the pawl and the ratchet of the clutch can be separated.
Check whether the clothes in the bucket are placed on one side, and there is a lot of noise when the dehydration is folded. At this time, the cover should be opened to place the clothes evenly. What to do if the washing machine does not get water>>
