What is the principle of the fish tank aerator
The working principle of the fish tank aerator is the same as that of the industrial aerator pump. The in-water method allows oxygen to enter the water. Because when the air and water are in full contact, oxygen molecules will melt into the water, so the amount of dissolved oxygen will increase, and the increase in dissolved oxygen will ensure the growth needs of oxygen-consuming organisms. Because of its convenient use, high efficiency and low cost, it is widely used in modern fish farming.
How to install the fish tank aerator
1. Assembly of the aerator
1. Take out the copper nozzle and connect the copper nozzle connector to the body.
2. Connect the connecting tube that comes with the body to the Liu split head, and then connect them to the connector of the copper nozzle of the body.
3. Connect the aerator tube to the sand head.
4. Connect the aerator tube with sand head to the 16-point head of the body.
Second, installation steps
1. Connection of distributor, air outlet and air stone
The air outlet can pass through the air outlet . The distributor is connected with one or more air stones, select the appropriate outlet pipe, and cut off the excess part properly during installation. The air outlet pipe with large hole and non-bending, combined with the air bubble stone with smooth air outlet, can effectively transport all the air. If the air stone is placed in the pool, the general concentration should not exceed 3 meters, and the air outlet should not be blocked when the air pump is working.
If the air stone is too small, too old, or too dirty, it will directly reduce the air output. Therefore, no matter what purpose it is used for, it should always be ensured that the air outlet is unobstructed, otherwise the aerator may heat up and cause damage. In order to prevent the water from flowing back into the aerator when the power is cut off, the aerator should be placed on the water level line, and if it is to be used at a place lower than the water level line, a check valve should be installed on the air outlet pipe.
The aerator should never be placed in the water at any time. In order to ensure a long service life of the aerator, it should be placed in a dry place with less dust, because humidity and dust will significantly shorten the service life of the aerator. It should also be noted that if the ambient temperature exceeds +40 degrees Celsius, it will accelerate the aging and rupture of the leather cup.
2. Removal and installation of the leather cup
(1) Loosen the four fastening screws and remove the outer air chamber.
(2) Loosen the nut, remove the cup pressure block, electrostatic diaphragm and cup respectively. When replacing a new cup, make sure that the positioning protrusion on the cup is aligned with the positioning groove of the inner air chamber .
(3) Install the removed parts in reverse order.
3. Cleaning and reinstallation of filter cotton
If there is any dust or debris in the air inlet of the aerator, it will cause noise or damage to the air pump of the aerator. Generally, the filter cotton must be cleaned or replaced every three months.
Precautions for the use of fish tank aerators
1. Before use, pay attention to whether the power supply voltage is consistent with the aerator.
2. Be careful of water immersion, sun exposure and impact to ensure normal life.
3. Do not immerse the aerator directly in water, and do not oil the air pump of the aerator.
4. When using the aerator, please place it at a position above 20CM above the water level. If it is below the water level of the fish tank, it is recommended that you use it with a stop valve.
Declare: The above methods are derived from the program system index or shared by netizens. They are for your reference only and do not represent the research views of this website. sex and authority.
